Write down the classification of the transmission line?

1 Answers  

---

How could a garment factory benefit from renewable energy

0 Answers  

---

How is the Depth of Stator Slot being calculated for Synchronous Generator?

2 Answers  

---

what is the difference b/w earthing and grounding??

2 Answers   Dodsal,

---

Can 2 nos. of 1 ton split ac be used through a 20 am supply meter?

3 Answers  

---

which circuit takes max. load & which circuit takes min. load i.e. SERIES CIRCUIT OR PARALLEL CIRCUIT??

3 Answers  

---

What is the List of Equipments, Instruments, Components required in Transmission of electricity from 1 substation to other substation(The equipments required in substation too)? What are the differnt IS standrds used for above equipments in Industry?

2 Answers  

---

In a company has been installed an analog amperemeter, this company was suplied by generator X, there is no problem in the ampere meter, rigth now this company's supplied by generator Y then the pointer in amperemeter vibrating. What happened? Why? Thank's

2 Answers  

---

Find active & Reactive Power transmitted in a transmisston line having Vs30 degree(sending end) to Vr(zero degree)at receving end with line inductance X ohm. Vs(30degree)-------------------Vr(zero degree) X ohm

3 Answers  

---

I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?

0 Answers  

---

how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.

0 Answers  

---

What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?

0 Answers  

---