Answer / anup sharma

Your steam turbine is extraction cum condensing turbine, high exhaust temperature may result either
Turbine is running at part load, extraction valve is minimum open (High extraction steam is being delivered) thereby lesser amount of steam is entering in to lower pressure section of steam turbine, which may increase the temperature of exhaust steam due to churnning effect, It is also known as windage, Lower the extraction, and see for change,
or
Check fouling of condenser tubes

explain how the third harmonic content of the magnetising current affects transformer design

0 Answers  

---

transformer shut down process.

0 Answers  

---

What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?

0 Answers   RasGas,

---

DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.

0 Answers  

---

Why the steam Turbines are Designed Higher side compare to Alternator

1 Answers  

---

How We Calibrate the vaccum transmitter?

0 Answers  

---

Planning Engineer interview model question and answer

1 Answers   Tata Power,

---

Boiler capacity is 5ton, what will be the feed water tank capacity?

11 Answers   dscl, Indiabulls, Krest, TCS,

---

how mony power plants in India

3 Answers  

---

what is water consumption rate of water to condense one ton steam in condensor.

1 Answers  

---

why not maintain Ph 7.0 in Boiler because 7 Ph is not acidic and not basic.

4 Answers   Atlas Power,

---

What happen when the AVR of the generator fails? Will it cause power instability and total failure of the alternator?

8 Answers  

---