Answer / powerplant.calculations

Refer following link for information on Excitation, PMG, AVR ,power generation in power plants
https://www.powerplantandcalculations.com/2020/05/pmg-excitation-avr-power-generation.html

Why high pressure turbines are single flow 

3 Answers  

---

Why attemperation is required in HRSG in a combined cycle power plant?

10 Answers   Tata Power,

---

some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor

0 Answers   UMT,

---

if suppose boiler has high heavy tube leakage, so in which time we feed the water in a boiler. can we stop the feed water at particular combustion temperature.

4 Answers  

---

why Subcritical has 60% condenser capacity

1 Answers  

---

What is indipendant power plant

2 Answers  

---

explain why direct on line starting toque and current may not be acceptable

2 Answers   Avon Organics,

---

why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..

3 Answers   GIPCL, OEGI,

---

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,

---

Why reheater is not used after IP turbine.

3 Answers   Hindalco, SEC,

---

What do mean by 3t

1 Answers   Aman, Birla, Grasim,

---

Why cold water is used for Boiler Hydro test

1 Answers  

---