what's interlock relay ?

Answers were Sorted based on User's Feedback



what's interlock relay ?..

Answer / tarun

The protective devices in switch yard are in interlock system if any circuit breaker does not trip under fault condition the next sequence breaker will trip for example bank locker key coustomer having one key and for same lock.bank employ have another key for opening locker

Is This Answer Correct ?    1 Yes 0 No

what's interlock relay ?..

Answer / pvl

Interlock relay is a type of protection system which senses some event and triggers corresponding action.
For example, NC relay for power supply will keep the supply up normally, but as soon as some fault occurs, it will change to OPEN contact and cut the power supply to the system. This action is called interlock and therefore the relay is named interlock relay

Is This Answer Correct ?    1 Yes 0 No

what's interlock relay ?..

Answer / k.prakashchandra

It is a multi-armature relay with positions of armatures dependent on positions of other armatures i.e positions are interconnected

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Power Plant Engineering Interview Questions

Is it not bad to bleed steam from turbine stages before utilizing its energy.

2 Answers  


We know primary ,secondary air so, What is the work of Tertiary air in Thermal power plant

2 Answers   NPTI,


How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.

0 Answers   Aevitas Pharmagro,


why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..

3 Answers   GIPCL, OEGI,


why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)

2 Answers  






What is critical speed of turbine

6 Answers   Vasavi Power,


operation

0 Answers  


how many safeties should be present in boiler?what are they?

4 Answers   DN, Nandi, Pump Technology, Siris, Thermax,


Why attemperation is required in HRSG in a combined cycle power plant?

10 Answers   Tata Power,


What is the formula for find out the height of chimeny of a powerplant?

2 Answers   Rosa Power Supply Company Limited, Sail,


What vibration parameters are monitored in a directly coupled single cylinder turbine and generator?

1 Answers  


Difference between directional earth fault and non-directional earth fault

2 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)