Answer / Pradeep Kumar Gautam

Calibrating a Coriolis flow meter involves the following steps:

1. Prepare a known volume of a calibration fluid (usually water or air).
2. Install the flow meter in a pipe, and connect it to a pump, pressure gauges, and flow rate controller if necessary.
3. Run the calibration fluid through the meter at various flow rates while monitoring the readings from the meter.
4. Compare the actual flow rate (from the known volume of calibration fluid) with the readings from the flow meter to determine any discrepancies or errors in the meter's readings.
5. Adjust the meter as needed, using manufacturer-provided instructions, to correct any errors and ensure accurate measurements.

I need to know steps to Calibration Valve Guard......

1 Answers  

---

Why DP level transmitter preferred for closed vessels and Radar level transmitter for open tanks??

2 Answers  

---

micromotion flow meter used for

3 Answers   Reliance,

---

what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?

1 Answers  

---

What is feed factor and its Importance in cement industry? How we can solve feed factor?.

1 Answers  

---

why use to 250 ohm for hart protocol and why hart communicator not communicate without 250 ohm 

4 Answers   OMV,

---

yogokowa field bus system transmitter all's we are geting IOP fault in Contiunes please help me fine how we can normal the broblems?

4 Answers   ABB,

---

what is sliding spool valves?

1 Answers  

---

What is two wire system and how it work

2 Answers   Bhel, IFFCO,

---

WHAT IS THE Differance b/w on/off & pid control valve?

10 Answers  

---

can i get any detail of interview question asked for instrumentation,plc,scada ,dcs..............

2 Answers   Asec, Honeywell,

---

Anybody can tell me  how to convert mmHg2o /psi to scfm  please give me formula of conversion

0 Answers   Samsung,

---