Answer / Swati Gaur

Calculating the vector group for a power transformer typically requires knowledge of the transformer's design, manufacturing data, and test results. This information is not publicly available without specific access or documentation. However, if you have access to this information, you can use the dot product method or the phase angle method to determine the vector group.

why we are used thermistor in motor

1 Answers  

---

What is the difference between the impedance percent and impedance voltage ?

1 Answers  

---

Is an SCR semi controlled device?

4 Answers   IOCL,

---

Haw to check conductivity of budbar

1 Answers   Adlec Power,

---

pls tell about gas insulated substation?which gas is used for that substation?above which rating we are used this substation?how we take maintenance in that substation?it means substation fully shutdown or live condition?if live condition means how?pls clear this things

1 Answers   Essar,

---

why we use to transmit the power in three phases intead of single phase ?

4 Answers  

---

what is the meaning of electrical maintenance?

3 Answers   GE Healthcare, MAHINDRA,

---

Pls explan the OLR setting in VCB at HT yard

1 Answers   Juniper Networks,

---

Why is negative feedback invariably preferred in closed loop system?

1 Answers  

---

What are the applications of the electric motors?

1 Answers  

---

The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?

1 Answers  

---

wats the procedure to calculate no of batteries for ups?

1 Answers  

---