how to find under ground cable fault ??? if our cable size is 95*4 then what wi

how to find under ground cable fault ???
if our cable size is 95*4 then what will load capacity
with far mull

Question Posted / gajendra

2 Answers
3642 Views
Imdad, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how to find under ground cable fault ??? if our cable size is 95*4 then what will load capacity w..

Answer / gajendra

if we will try as cable resistance ya other Margare meter but in short cable condition always show Resistance. pleas tell me how we can find and what is correct answer

Is This Answer Correct ?

0 Yes

0 No

how to find under ground cable fault ??? if our cable size is 95*4 then what will load capacity w..

Answer / pas

Disconnect the both side cable.after disconnect the cable check by meager meter.meager one lead for earthing second lead for conductor.reading show in mega ohm.if cable was short reading reading showing infinity.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why transformer are not used in D.C SUPPLY

5 Answers

why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?

0 Answers

400Kv,can it be generated?why?

2 Answers

i am swathi, b.tech 4th year. In smps(switched mode power supply)we are using diodes,mosfets,igbts for controling of current. And my question is why we did not use thyristors(scr)? it is also act as a switch,then what is the drawback of scr as compared to above transisters> if we use the scr,then what is happening ? plz give reply as soon as possible bcoz i am doing project on smps. plz frnds i want ans for that. if anybody know the ans plz send to my e-mail id /swathi.tadakapally@gmail.com/

5 Answers EEE, TCS,

for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance

0 Answers

design of IGBT firing circuit for 11KV

0 Answers

what are the installation procedure of high voltage power transformer,CT,CB&PT?

0 Answers Siemens,

How the main bus bar rating of 400kV switchyard with one and half breaker scheme is calculated.

2 Answers

What is meant by stator?

0 Answers

Rated moter voltage and frequency is 380volt 60 hz but moter is running at 380votac 50hz is this harmful for moter winding

1 Answers Infosys,

why we earth only one side of a power cable. And which side is advisable to earth.

1 Answers

why a motor rating in KW?

7 Answers ABG Shipyard,

For more Electrical Engineering Interview Questions Click Here