Can be ammeter and voltmeter used without CT? if not, what is the reason for tha

Can be ammeter and voltmeter used without CT? if not, what is the reason for that?

Question Posted / asivasankar2k

3 Answers
5534 Views
Elektrotek, Toyo Engineering, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Can be ammeter and voltmeter used without CT? if not, what is the reason for that?..

Answer / sameer

if you are measuring current at the high voltage line have current 60Amp then you cannot connect the ammter directly you have required CT whose scondary is connected with the ammeter . same as for voltmeter if range beyound 750volt measure you need to connect voltmmeter to Pt

Is This Answer Correct ?

9 Yes

1 No

Can be ammeter and voltmeter used without CT? if not, what is the reason for that?..

Answer / aap

Please elaborate your question correctly.

Is This Answer Correct ?

3 Yes

1 No

Can be ammeter and voltmeter used without CT? if not, what is the reason for that?..

Answer / harshith b c

Below 750 voltage rating you are calling as Low Voltage level so their you can connect easily .More than that calling as MV(Medium Voltage ) or HV(High Voltage) there u need PT because of the ability of the meter.Even in Current also the same criteria.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Can u Explain about the electronic trivector meter and the use of data converters in them?

0 Answers Tricom,

How many kw will suply from one db

0 Answers

Sir we are using 250 kva DG its Diesel consumption 25 lits / hrs maximum load 160 kva now how to calculate units/ litres

1 Answers

if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?

0 Answers

how to control the speed to switched reluctance motor

0 Answers

what is the installation process for lifts

0 Answers DLF,

i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.

0 Answers

what is ACB and its function?

3 Answers

why we ground the scondary of current transformer.

4 Answers

Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?

0 Answers

Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss

0 Answers

A 3 phase motor operating off 415V system is developing 20Kw at an efficiency of 0.77 and power factor of 0.73. determine:- a)the line current. b)the phase current if winding are delta connected. c)the phase voltage if winding are star connected.

1 Answers

For more Electrical Engineering Interview Questions Click Here