Sir we are using 250 kva DG its Diesel consumption 25 lits / hrs maximum load 160 kva now how to calculate units/ litres
if a single phase 3 hp submersible pump of Crompton Greaves is moving in reverse direction and sometimes it moves in rigth direction ,then what may be the cause....
using in R,Y& B PHASE LTSIDE(415V)ct ratio 4000/5 WITH ENERGYMETR OF 1280 REV./KWH,240V.WHAT WILL BE MF OF METRE.
What is class 2 coordination ?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Is it necessary to carry out sheath test after cable jointing? If the value is zero of such instance , is it ok to energize the cable?
How a band pass filter is constructed?
if we increase the frequency given to a transformer then wat will happen to the transformer size, whether it will increase?
where this neutral connection goes after returning from the load(home ,factory,industries).Is it grounded at the transformer side or atthe generator side .If it is grounded then we also ground the earth connection.is there any problem with this.
what are the interview question asked in wind mill about electrical
why the generating voltage in India is 11kV or why is it be transmitted as multiples of 11
34 Answers ACC, Bhel, ECI Engineering and Construction, NTPC, SBL, Senthur Power Services,
When oil level in the oltc of power transformer reduces , oil surge relay will act or not
Need help. 3 phase system. Neutral line arced and melted upon connection of connector with 3 phase power. Why would that happen?