Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


15. What is the difference between first angle projection and third angle projection?

Answers were Sorted based on User's Feedback



15. What is the difference between first angle projection and third angle projection?..

Answer / yunus m

In First Angle projection Object lies between Viewer & the projection view. (Plane of projection will be center). In third angle projection projection View lies between Viewer & Object.

Is This Answer Correct ?    14 Yes 0 No

15. What is the difference between first angle projection and third angle projection?..

Answer / jaydip polara

* in 1st angle projection drawing the top view is draw below of front view.
in 3rd angle projection drawing the top is draw above of front view.
* in 1st angle projection drawing the right hand side view draw in left hand side of front view.
in 3rd angle projection drawing the the right hand side view draw in right hand side of front view.

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More Mechanical Engineering Interview Questions

how the efficency of a coupling is calculated?

0 Answers  


what is the procedure getting road permit form online

0 Answers  


what thermo

0 Answers  


Abhinav Bharat? was organized by

1 Answers   RRB,


what is the thermal efficiency of SI engine with range value?

2 Answers   Sail,


Where does Parallel flow heat exchanger use?

0 Answers   Bhel,


What causes turbocharger surging?

0 Answers  


HYDROLICS

2 Answers   NHPC,


Which of the following pairs is correct ?

0 Answers   RRB,


whats the range of poissons ratio of a stable material??

3 Answers  


how to design a crankshaft?

0 Answers   TATA, Tata Motors,


what should be the correct duration of slow firing of the coal based and biomass boiler?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4456)
  • Electrical Engineering Interview Questions Electrical Engineering (16639)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)