Answer / dhananjay

It's depends which contect used in proximity.
I.E. Proximity with NO contect will show voltage how much you giving.Supose you are giving 24 volt than it will show 24v.

And now Supose you have proximity switch with NC contect and you are giving 24volt than you will get 0(zero)Volt around.That means drop voltage.

what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?

0 Answers  

---

how can loop single 4-20 ma to two isolation amplifier? i mean i have two isolation amplifier with 4-20 ma input and 1-5 v output.can i done series connection ?

1 Answers  

---

what is difference between fork type and capacitance type level switch. where it is using

0 Answers  

---

Why do we have earthing cable in branch cable and shield in the same cable?

0 Answers   Process Control Technologies,

---

yokogawa Temperature transmitter showing Error 15 which is Reverse Cal Fail (confirmation calculation result is bad) in manual they mentioned reasion That the output goes to the value set by hardware failure mode jumper. How can solve this problem ? anybody can say solution

1 Answers   GTL,

---

What is the IEC Standard for PLC I/O Terminal wiring Procedure?

1 Answers  

---

who discoverd ohms law?

3 Answers   HPCL,

---

Control valve question what is the meaning of cauge.?what is the use of cauge?

1 Answers  

---

what is thermo coupler and how it works

2 Answers   Tisco,

---

what is the tempareture conpensation?what is the use of this?

1 Answers  

---

if I did short to both AO connections, channel will burn or what? m sure in AI it will damage to channel. But what will happens in AO?

1 Answers  

---

What is the use of the shield wire and how is the connection at both the ends of a shield wire?

2 Answers   Samsung,

---