3ph line voltage 220v, how can run a 220v single ph motor or Light?

Question Posted / uttam

2 Answers
3429 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

3ph line voltage 220v, how can run a 220v single ph motor or Light?..

Answer / k.prakashchandra

Connect the motor to two phases

Is This Answer Correct ?

4 Yes

1 No

3ph line voltage 220v, how can run a 220v single ph motor or Light?..

Answer / abhishek khandelwal

ABCB - Air Blast Circuit Breaker
MOCB - minimum oil circuit breaker

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is preventive maintenance? and what is predictive maintenance? and what diffrence both?

3 Answers Volkswagen,

What does the letter CTNM in negative phase sequence relay means?

0 Answers

What is floating earthing?

2 Answers Equate,

In a company has been installed an analog amperemeter, this company was suplied by generator X, there is no problem in the ampere meter, rigth now this company's supplied by generator Y then the pointer in amperemeter vibrating. What happened? Why? Thank's

2 Answers

The CHARGED BATTERY GET DISCHARGED WHEN IT IS NOT IN USE FOR LONG TIME.GIVE REASON.

1 Answers

WHY WE CAN GENERATE POWER IN 3PHASE MODE ONLY NOT IN 4 OR 5 PHASE?

10 Answers

What is the difference between a verilog task and verilog function?

0 Answers

For an 100kw generator, only 50kw of load is connected. will the generator generate only 50kw or 100kw. if it generate 100kw what happens to rest of the 50kw. what happens if we connect more than 100kw of load?

8 Answers

which oil is used in transformer?

7 Answers

Why the size of transformer decreases if we increases the frequency?

5 Answers Graphics Engineering,

We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?

0 Answers Siemens,

I completed my BE EEE degree 2006 .... which license should i apply .... ?????

0 Answers Real Estate,

For more Electrical Engineering Interview Questions Click Here