Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
No Answer is Posted For this Question
Be the First to Post Answer
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
break down of electricity is more in summer or in winter ? give reason
what is the principle of servo motor
why our indian system choose the 230 volt for single phase&415 for 3-phase voltage,in forign side 110 volt is used what is the difference
How to calcualte 1unit of current consumption?
3 Answers Bhushan Power Steel, ITC Infotech,
what is formula of illumation calculation
Frequency of rotor emf in induction motor is around A same as stator frequency B 50% C 5 % or below D 30%
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
We are having a 2000KVA DG set. It trips with Over speed and Engne Hot when the mahine is stopped in full speed. How shall I analyse the block load and reverse power.Is the problem related to power factor. The machine which runs on this DG is having all Synchronous motors with incividual Drives.
A FIELD MAGNET IS EXITED BY AC/DC?
which is better VCB or ACB and why?
Why Closing coli supervision is not required for Circuit breaker.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)