break down of electricity is more in summer or in winter ?
give reason
Answers were Sorted based on User's Feedback
Answer / ks chiranjeevi
Due to heat, the transformers will get heated up and the
inside oil viscosity will become lesser and the transformer
primary and secondary coils will be short circuited.
Due to less water availability, the Hydroelectricity will
becomes less leads to shortage of power.'
Due to heat in summer, the turbine connected alternators
will become prone to more heat compare to normal heat in
other seasons, the unit trips.
Due to heat in atmosphere, the people draws more power
through water coolers, air conditioners, etc., and shortage
in power causes power breakdowns.
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / mohamad a.monem salama
IF THE CONSUMPTION IS MEANT , IT DEPEND ON THE NATURE OF
THE LOAD.SOME COUNTRIES THE CONSUMPTION IS MORE IN
SUMMER ,THE OTHERS ARE IN WINTER .IN ARAB GULF COUNTRIES
THE CONSUMPTION IN SUMMER TWISE THAT IN WINTER BECAUSE OF
A/C LOADS.IN UOROPE IS DIFFERENT.
| Is This Answer Correct ? | 0 Yes | 2 No |
Answer / chitrupiscean
breakdowm of electricity is more in winter bcos when the
temperature in winter decreases then resistances of
transmission lines also decreases , hence increases the
current carrying capacity of conductor . and more current
flows through transmission lines .hence break occurs more in
winter
if any body has better answer then most welcome
| Is This Answer Correct ? | 1 Yes | 5 No |
1. what is the meaning of bus? 2. what is the dc transformer? How it work 3.what is the function of the serge absorber? 4.How the CT and PT rating calculate/
when turbine trips generator will becomes induction motor or synchronous motor?
when will cause the negative sequence falut in electrical system?
why we use sinosidal voltage / current instead of others in system?
what is the clearances between phease to phease & phease to earth in 400 kv transmission line?
why we use 50hz frequency in india why not other frequencies like 52,59,42 etc
What type of fittings and electrical accessories can be install in radiation area ?
why power factor laggs and leads in case of inductance and capacitance??
why induction motor having low power factor at starting time and high at full load.
What is the operating principle of turbo-generator.
How to calculate the current rating of power cables ?
what is advantage of providing taping on HT side?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)