Answer / sam

There are some difference in some areas like "area" in sq
feet and tons of force but nothing that concern us in
instrumentation. PSI is PSI all over the world and so is all
other units of measure we use in instrumentation. The UOM
that are slightly different between US and UK is not of any
importance to us.

All of these difference are also in the imperial system and
there are no differences when you work in the metric system.

In the area of pressure specifically, there is only the ton
of force that are only 1,2 more than the other and that is
not something you will ever use. The same is true for all
other UOM for temp, flow, level, density and all the ones we
use.
Good luck

For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?

0 Answers  

---

Where is wet leg is used?

0 Answers  

---

I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?

3 Answers   OPaL,

---

how to use K thermocouple instead E- type without compesation cable

1 Answers  

---

PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear

0 Answers   MSL, SRAAC,

---

In 2 wire transmitter 1 wire is used for power and other is used for signal( 4-20)ma In 4 wire transmitter 2 wires are used for power and 2 wires are used for signal (4-20)ma . but my question is "what is the criteria or parameters we have to consider while selecting these transmitters for eg( distance, safety zones etc.

1 Answers  

---

Any can guide for QA/QC Inspector in oil & gas region, the procedures, formats standards, design criteria, i search in all enginees but i can't found wat i need?????????

4 Answers   Aramco, Asian Paints,

---

whatis diference between zero pressure and obsolute pressure

1 Answers   ABB,

---

How to convertion 100 m3/hr to mmH2O or to Kg/cm2?

0 Answers  

---

Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?

0 Answers  

---

What are different types of valves?

0 Answers  

---

How to calculate flow of air bubbler type level transmiter  According hight and density 

2 Answers   Qatar Petroleums, RKS,

---