Answer / k. ksharma

All electronic device are operated to 24volt DC supply. Two terminal positive and negative, negative wire comman for each loop.

Answer / carl_ellis

24Vdc is the DC power supply voltage.

For 2 wire loop powered instruments, the DC power supply is
in series in the loop.

For 3 wire instruments, the DC power supply common (-)
shares a terminal with the receiver's common (-),

but has a separate (+) terminal.
For 4 wire instruments, there separate wiring terminals for
both the power supply (+) and (-).

Carl Ellis
Measure First

when we are using HART COMMUNICATOR why we are using 250 ohm resistance while using HART COMMUNICATOR.

7 Answers  

---

what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.

1 Answers   ADMA OPCO,

---

What is loop checking ?

10 Answers   Kharafi National, Petrofac, Samsung,

---

two common seiling liquid used in seal pots are:

1 Answers   Thermax,

---

What should be hight of CONTROL panel for access & OPERATION What is BIS & INDIAN STD for SAME?

3 Answers  

---

Explain signal isolator

1 Answers  

---

We are used CENTUM CS3000 of YOKOGAWA. please tell me how to simulate wihtout FCS and vnet.

1 Answers  

---

Please asked me How calculate DCS controller memory.

1 Answers   Yokogawa,

---

Where we r using split range and ratio controller?

1 Answers   EID Parry,

---

pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)

1 Answers  

---

What is the role of P(Protional), I(Integral) and D (Derivative) in PID Controller?

9 Answers  

---

Will Intergraph support SmartPlant Instrumentation in an AutoCAD or MicroStation environment on a long-term basis?

1 Answers   Siemens,

---