Where we use 30mA , 100mA & 300mA RCCB ?

Question Posted / kitty

3 Answers
43001 Views
BEL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Where we use 30mA , 100mA & 300mA RCCB ?..

Answer / ragavan

The most widely used are 30 mA (milliamp) and 100 mA devices. A current flow of 30 mA (or 0.03 amps) is sufficiently small that it makes it very difficult to receive a dangerous shock. Even 100 mA is a relatively small figure when compared to the current that may flow in an earth fault without such protection (hundred of amps)

A 300/500 mA RCCB may be used where only fire protection is required. eg., on lighting circuits, where the risk of electric shock is small.

Is This Answer Correct ?

20 Yes

11 No

Where we use 30mA , 100mA & 300mA RCCB ?..

Answer / libin t panicker

for industrial Purpose which kind of RCCb requied for Welding Machine.
ELCB or RCCB which is best,? please give the Specificstions

Is This Answer Correct ?

8 Yes

3 No

Where we use 30mA , 100mA & 300mA RCCB ?..

Answer / vipul parmar

these type of RCCB in domestic use only.

Is This Answer Correct ?

11 Yes

13 No

Post New Answer

More Electrical Engineering Interview Questions

What is the Power factor of DC Power system ?

9 Answers

How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav neutral)Thn we go for step down transformer.Our load 10 amps,so we conisder this amps in primary are secondary side

1 Answers

Mention the value of earth resistance and factors on which it depends on.

1 Answers

How to calculate impedance volt in Transformer?

0 Answers

Why oil preferred over the air as a cooling medium for high rated transformer?

1 Answers

What is the required value while doing the megering

1 Answers

What are ampers.30kw motor.440volts.

5 Answers Pam Glatt,

THE 40 MW OF POWER FOR 220 V III PHASE POWER CONNECTION REQUIRES HOW MANY KVA POWEER REQUIREMENTS

7 Answers Chartered Accountant,

What is basic fundamental for choosing NGR or NGT for any generator neutral grounding

5 Answers EDF,

wat do knw aboot circuit breakers ?

9 Answers IOCL,

In a 11000/440 V transformer, when any one phase of 11 KV supply fails (ie., single phasing), what happens to the secondary voltage and why?

3 Answers Secure Meters, TCS, Torrent Power,

In any Industry, Which voltage level either 3.3kV or 6.6KV to be chosen? Then I would like to know ,Is there any cost consideration or Rating of motor?

5 Answers

For more Electrical Engineering Interview Questions Click Here