what is the acceptable limit value for Desolve Gas Analysis/
No Answer is Posted For this Question
Be the First to Post Answer
why we use lamination or layer by layer cor used?
exact definition of reactive power in power system
transformer test
1.What will be stored in online ups EPROM IC?
What does ampere turns shows?
what is IMPEDENCE? FORMULE?
what are the functions of fuse ?
why the substation require din electrical system?
what is the difference between high impedance and low impedance circuit?
why do we provide metallic enclosure to bus duct and then ground it?
What is the range of efficiency of thermal or steam power plants? Why it is so low?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.