What is minimum permicible value of leackage current for LT
Panle when applying voltage up to 3 KV for 5 Minuits?
No Answer is Posted For this Question
Be the First to Post Answer
my motor rating is 800HP, 128Amps, 3.3kV. What is capaitor bank i can use for PF improvement to 0.990?
132/66kv sub-station procation ?
why we are caling 440 volt 3 phase supply instead of 660 volt 3 phase supply? because each phase as a voltage of 220 volt. if anybody know the answer for my question please send it to my mail id. thank you.
3 Answers College School Exams Tests, Jindal Steel and Power, JIOL, NEC,
At a family reunion were the following people: one grandfather, one grandmother, two fathers, two mothers, four children, three grandchildren, one brother, two sisters, two sons, two daughters, one father-in-law, one mother-in-law, and one daughter-in-law. But not as many people attended as it sounds. How many were there ?
transformer test
Why is copper a better conductor of electricity than aluminium?
what is power factor? is it good or bad for a system? what will happen if power factor increase or decrease?
why abcd parameters are called as transmission parameter?
Why temperature rise test is conducted in bus bars and Isolators?
How we can differniate the overhead lines feeded by hydro power stations & thermal power stations
DEAR ALL I have motors ( 10 units )each one is 90kw 380V 50 HZ 1000rpm but new local pwer is 220v 60 hz requierd rpm should be 1000 pleas what the beast solution is used frequncy converter or rewinding all motos or chang all motors thanks
why do we not use equivalent voltage source in negative sequence equivalent ckt.