What are the motors used in a thermal power plant? (With
type and ht/lt)
What voltage levels are used in a thermal power plant?
Answers were Sorted based on User's Feedback
Answer / ankit
mostly 3 ph induction motor are used in thermal power plant for
condensate extraction pump
cooling tower fan
reactor cooling fan in nuclear power plant
boiler feed pum
vlotage level of such IM are
3.3KV,6.6kv, 11KV
Is This Answer Correct ? | 22 Yes | 0 No |
Answer / suresh kumar
Other than above, there is dc motor for oil lubrication in black out condition.
Is This Answer Correct ? | 5 Yes | 0 No |
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
what is the perfect location for furnace draft transmitter in AFBC boiler?
What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?
voltage and frequency is equal but synchronisation not complete why?
Why we need to maintain furnace and secondary air dp.if it increase or decrease what happens.
Can any one advised me how we can measure the losses in a 11kV/415v power transformer? We have no access to the incoming mains into the primary of the transformer. Can one derive something useful by measuring temperature rise in the transformer?
Why attemperation is required in HRSG in a combined cycle power plant?
.What do you mean by Turbine Dump.
Why attempration spray is used after hp heater?
5 Answers CMJ Breweries Private Ltd., Thermax,
What happens if there is no HP and LP By-pass.
.What are the equipments should run when there is a black out in power plant.
if suppose boiler has high heavy tube leakage, so in which time we feed the water in a boiler. can we stop the feed water at particular combustion temperature.