our 125 kva DG does not start in AUTO mode
works normally in MANUAL mode please give me a solution.....
No Answer is Posted For this Question
Be the First to Post Answer
What is excitation current and voltage in hydro power plant ?
why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..
why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)
How do you consider that you can improve and what assistance do you need to achieve this
what is voltage transformer explain in details
5 Answers Khulna Power, NCC, Reliance Power,
What is LB-SR.
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
What is droop.
2 Answers Dhampur Sugar Mills, Elaf,
explain why direct on line starting toque and current may not be acceptable
how shall you calculate PLF on the basis of percentage auxillary load factor
In a coal fired boiler furnace temp. is high but super heater out let temp. low what reason for this?
6 Answers ABB, Essar, Gayatri,
In turbine. why they not use 320 oil?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)