Answer / rama

ans : horizontal. because vertical joint can easily damage during earthquake or other lateral force like wind load. so compared to vertical joints, horizontal joint may be better.

Answer / shaikh sayeed

Construction Joints should be minimum in execution. and the
location is to be decided carefully. Constr. Joint should be
at right angle to the span of member. e.g horizontal in
vertical columns and vertical in horizontal beams. Flexural
Strength of member due to construction joints depends upon
prepration of surface before making a joint, location of
joint. ref: Design and contruction of joints in concrete
structure, M.N Bussel

time and work questions

0 Answers  

---

how many digree of freedom in four bar chain

0 Answers  

---

how to carry out rate analysis for RCC work in column using M20 ?

1 Answers   Mazna Building Contracting,

---

how you calculate the data (all parameter) after transient response method i.e.pile intigrity test on pile.

1 Answers  

---

How to Calculate Materials Required for PCC 1:4:8 for 1Cum & Brickwork 1:4 for 1Cum & Plastering 1:4 (15mm Thick) for 100Sqm & RCC 1:4:8 & 2mt ( L1=1mt & L2=1mt ) length of 12mm Steel bended in 90degrees what is the formula to calculate Weight & Actual Length ?

0 Answers   Nespak, Xebec,

---

---

if 6.0M x3.0M Boat floating on water One person Sit on Boat Then the boat Sink about 15cm .Then what is the wt of person.

3 Answers  

---

How and where from do we get 162 for calculating sectional weight of TMT

1 Answers   Ankit Metal Power,

---

With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr

0 Answers   Power Plant,

---

How do you prepare Material Recovery Statement for deduction from contractors bills?

0 Answers   RNA,

---

WHAT IS NON DESTRUCTIVE TEST?PLEASE GIVE ME THE PROCEDURE?

3 Answers  

---

what is the difference between linear and curved elements?

0 Answers   Al-Hamd Academy,

---

convert 1cum how many kilo

7 Answers  

---