Answer / niks

In triangular configuration inductance is of low value then
that of straight line configuration. Low value of inductance
increases power transfer capability and posseses several
other advantage hence it is preferred.

Answer / jithendra

phase to phase clearance

In High voltage 11KV min 400mm 33kv 600mm distance should be maintain, so they are formed in triangular (it is called as triangle formation)

what are the advantages by using IGBT in VSC HVDC than thyristor in conventional HVDC

1 Answers   Bhel, Eskom,

---

why anti pumping relay is not given to tripping coil of the breaker? why only to closing coil?

2 Answers   INEL, Siemens,

---

What is the purpose of stand by earth fault protection for transformer ?

0 Answers  

---

What are the advantages of D.O.L Starter in 3 phase induction motor?

4 Answers  

---

what are factors to be consider to design a HT & LT motor?

0 Answers  

---

if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side

0 Answers  

---

What is the high tension lines voltage and low tension lines voltage?33 kv is high tension line or low tension.

1 Answers   MPSEB,

---

Why we call cable rating in SQ.mm.If it is 240 SQ.mm how much the diameter possible?is there any calculation ?

4 Answers  

---

What is voltage 

4 Answers  

---

what is the exact direction of current? as we know current travels from higher potential to lower potential,so if we take battery +ve to -ve implies current direction is from positive terminal to negative terminal.,whereas electrons flow from negative to positive as they are attracted by positive ions.current will be the plow of charge but not flow of positive ions.please clarify my doubt friends.

2 Answers  

---

I have 380.KVA Volva Penta DG set. Tell me how to calculate units from KWH reading....

3 Answers  

---

hi frienda We have 750kva cater pillet dg set we are fasing one diffrent proublam in dg we are start dg set after one mint applying load around 450a load but dg was run 3 Or 4 mints after 3 mints dg was shuding down automatic how to face this proublam pls tel any budy

1 Answers  

---