How can a d.p. Transmitter be calibrated?

0 Answers  

---

2. What is ultrasonic flowmeter?

1 Answers  

---

Why the Air Tank Accumulators required for the single acting actuators SDV's or BDV's as I see in some Schematic diagrams of ROTORK ??

2 Answers   L&T, Siemens,

---

Steve said that "An eddy-current probe works by passing an alternating current through a coil of wire and measuring the coil’s impedance" while we are using -24 Volt DC , So I am confused about DC and AC. Plz .

2 Answers   Jindal, Sadara Chemicals,

---

Why Instrumentation Air Compressor called as Instrumentation Air compressor?pls dont just tell its trasferring IA to all transmitter,valves.I need exact reason, please......................

2 Answers  

---

Please explain the difference between instrument range and calibration range in terms of pressure transmitter? line design pressure: 93 bar operating pressure : 82 bar press Transmitter Range? calibration range ?

3 Answers   L&T,

---

what is formula for calculating flow if i have pressure and pipe diameter?

1 Answers  

---

How to calibrate Magnetic flow Transmitter in Field

0 Answers  

---

In Increasing temperature why thermocouple used and RTD is not used. Both RTD and Thermocouple have in Range of uses.

5 Answers   L&T,

---

what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?

0 Answers  

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

how to calculate range of level transmitter?

0 Answers   TCE,

---