Answer / vino

Devices such as ultrasonic flow equipment use the Doppler frequency shift of ultrasonic signals
reflected from discontinuities in the fluid stream to obtain flow measurements. These
discontinuities can be suspended solids, bubbles, or interfaces generated by turbulent eddies in
the flow stream. The sensor is mounted on the outside of the pipe, and an ultrasonic beam from
a piezoelectric crystal is transmitted through the pipe wall into the fluid at an angle to the flow
stream. Signals reflected off flow disturbances are detected by a second piezoelectric crystal
located in the same sensor. Transmitted and reflected signals are compared in an electrical
circuit, and the corresponding frequency shift is proportional to the flow velocity.

What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows   very argent : my mai is merajalam143545@yahoo.com

0 Answers   Samsung,

---

How to calibrate the flow transmitter

0 Answers  

---

Exothermic reaction./ endothermic reaction

0 Answers   CCIE,

---

Please explain about FAT? What is the difference between FAT and SAT?

6 Answers   IBM,

---

I want to take temp. data from recorder to computer. Which communication system is best from this option(Rs 232- 485/ethernet/USB)?

3 Answers  

---

Definition of reverse and acting controllers:

0 Answers   Monnet,

---

I have 475 hart communicator. this is not support any new type of instruments such as tranmitter,fieldvue DVC6200.DVC 200 since i got point out need to upgrade . my questions is how can upgrade new instruments software in my 475 hart communicator. can any answerplease>?

1 Answers  

---

in DCS or PLC we can not put all ai or di,there is calculation through which we can accomodate certain no of digital and analog signal.I need to know that calculation

1 Answers  

---

what is the way of measuring air flow in air duct?explaim instruments used and DP creation in line?

3 Answers  

---

how to use one 4-20mA signal for two indicater or controller & give necessary precaution.

2 Answers  

---

how to commission furnace ( water heater)

0 Answers   Petrofac,

---

How to connect field devices to PLC and DCS using a FIELD BUS, DP,MOD BUS(please tell me any extra interfce or adopters need in this case if we use remote i/o s)

3 Answers  

---