Steve said that "An eddy-current probe works by passing an alternating cur

Steve said that "An eddy-current probe works by passing an alternating
current through a coil of wire and measuring the coil’s
impedance" while we are using -24 Volt DC , So I am confused about DC and AC. Plz .

Question Posted / rifhan

2 Answers
3498 Views
Jindal, Sadara Chemicals, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Steve said that "An eddy-current probe works by passing an alternating current through a coil ..

Answer / dhankhandhar@ymail.com

We can never generate DC voltage ,we can only change AC to DC ,so no matter you are giving AC or DC input but Addy current will be always AC.

Is This Answer Correct ?

0 Yes

0 No

Steve said that "An eddy-current probe works by passing an alternating current through a coil ..

Answer / niraj

We are giving 24V DC to Vibration probe is having driver circuitry which will generate AC signal for eddy current

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

Identification of ss fittings, pilot valves, relief valve.

0 Answers CCIE,

Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd

0 Answers

Why we use 250 ohm resister in series hart communicator?

3 Answers Thermax,

what is control valve input and out put

10 Answers Nirma,

What is the role of integral in PID controller

3 Answers

what is fire and gas system?

2 Answers Andhra Petrochemicals Limited,

How to calibrate radar lt type transmitter

1 Answers NTPC,

Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.

0 Answers Reddy Labs, ScienceWay,

why metallic housing is provided of solenoid valve.

1 Answers HPCL,

can i use capillary type dp transmitter converted to capillary type pressure transmitter. if i removed one side capillary tube its work correctly?

1 Answers

Why the tapping connections are taking above for gas service and below for liquid service?

4 Answers

need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate

0 Answers

For more Instrumentation Interview Questions Click Here