One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA t

One 200 V, 100 W bulb is connected in series with primary of
a 200 V, 10 kVA transformer. If its secondary is
kept open circuited, then the bulb would have
(1) Full brightness (2) Poor brightness
(3) A little less than full brightness (4) More than full
brightness...explain

Question Posted / sm

2 Answers
9357 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its s..

Answer / ajay

Wen X'mer is open cktd. Secondary current became zero. Very small current drawn by primary which supplies copper loss as well as iron loss. So brightness i.e. Power P#vicos@ will becm low. & poor brightness of the bulb seen

Is This Answer Correct ?

11 Yes

2 No

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its s..

Answer / ajayiet

when transformer secondary
is open it is at no load means
only no load current will flow
to supply the losses .but luk at
the rating of machine 10000
va so full load current is 10
kva/200 v i.e. 50 amp.now no
load current is 2 to 6 percent
of full load current i.e. 1 to 3
amp.resistance of lamp is 200
ohms so at no load wattage
i^2R is from 200 to 600
watt.so bulb will be
damaged.option is more
appropriate.

Is This Answer Correct ?

2 Yes

5 No

Post New Answer

More Electrical Engineering Interview Questions

What is an 86-P or an 86-A trip

0 Answers

how encoder works?

1 Answers ITC Infotech,

how external lighting design? please give examples?

0 Answers

when is the Ohms law is applicable?

11 Answers ABB,

Do you know how to measure the earth resistance?

7 Answers Manhattan,

what is diffential relay? testing proceure?and transformer reach Over load thet time differencilal relay operate or not ?

5 Answers

WHY AIR COMPRESOR IS STARTED UNLOADED

3 Answers

Why Nutral CT rating for Earth Fault Protection of Transformer neutral shall be 20% of Full load Current of Transformer

2 Answers

Dear Sir / Madam, Actually we requied 64 A MCB, But i have 32 A MCB = 2 No's this two i have to make series connection and we usw any place? isit possible or not......

4 Answers Hindustan Unilever Limited,

What is an isolation transformer?Why do we need isolate circuits?Where do we use them?

2 Answers

in most industies hormonics present up to some level. what is limit ? and there effect?

4 Answers Bhel,

If DC supply is given to a transformer it may a) Work b)Not Work c)Give lower voltage than the rated voltage on secondary side. d)burn the winding

12 Answers wbsedcl,

For more Electrical Engineering Interview Questions Click Here