Providing and constructing 150 mm thick brick masonry with
brick in cement mortar ( 1:4 ) in partition walls, pilars,
pedestals,supports etc. at all floors including RCC band at
1.0 M intervals, including scaffolding racking out joints
and watering cleaning complete in sqm.

Providing and constructing 230 mm thick brick masonry in Cum
Providing and constructing 460 mm thick brick masonry in Cum

Please provide me the rates..






Providing and constructing 150 mm thick brick masonry with brick in cement mortar ( 1:4 ) in parti..

Answer / rustam jamal

230mm thick Wall = Rs. 4455/- per Cum
460mm Thick Wall = Rs 4455/- Per Cum

Is This Answer Correct ?    0 Yes 0 No

Post New Answer




More Civil Engineering Interview Questions

What is the difference between shuttering

20 Answers   Comet,


what is the max diameter of bar will provided in 100 mm thick slab

1 Answers   Guru Tech,


What are the tests required to check the Quality of steel?

6 Answers  


concrete strenght is increased if using sisal fibre in concrete?

1 Answers  


Describe about the Pile test methods, which are used in Industrial & Multistory Buildings in general.

0 Answers  






Formula of mid span bar

0 Answers   Modern Construction Company, PFPL,


how much quantity of binding wire required for tieing of 1mt of reinforcement bar?

5 Answers  


How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel

0 Answers   Wonderla Holidays,


HOw many cement bags are required for M35, M40 & M45 grade of concrete?

1 Answers  


Anyone have sample questions for bhel interview.please send me as Iam appearing for the interview on 19th sep2008. Kindly send this to my e-mail: arun_prasath_n@yahoo.co.in

0 Answers  


20mm thick sand face plaster on walls consisting of 12 mm the backing coat of c.m.(1:3)and 8mm thick finished coat of c.m.(1:1)including scaffolding, watering, finishing etc complete please calculator with methyl et et r u

0 Answers   Dhruv Construction,


In a beam tension is always at the bottom but sometimes when we design using staad we get more number of rebars at the top compression zone Why?

1 Answers  






Categories
  • Civil Engineering Interview Questions Civil Engineering (4637)
  • Mechanical Engineering Interview Questions Mechanical Engineering (3700)
  • Electrical Engineering Interview Questions Electrical Engineering (15765)
  • Electronics Communications Interview Questions Electronics Communications (2636)
  • Chemical Engineering Interview Questions Chemical Engineering (762)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (79)
  • Bio Engineering Interview Questions Bio Engineering (30)
  • Metallurgy Interview Questions Metallurgy (95)
  • Industrial Engineering Interview Questions Industrial Engineering (199)
  • Instrumentation Interview Questions Instrumentation (2879)
  • Automobile Engineering Interview Questions Automobile Engineering (171)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (41)
  • Marine Engineering Interview Questions Marine Engineering (62)
  • Power Plant Engineering Interview Questions Power Plant Engineering (170)
  • Engineering AllOther Interview Questions Engineering AllOther (1334)