Answer / abhishek

petrol engine cant be started with diesel as diesel need higher temperature for ignition but diesel engine could be started with petrol. But it will just start and then will cause knocking.

Answer / velmurugan.v

we can't. because petrol engine is a spark ignition engine
whereas diesal engine is a compresion ignition engine.. i
think we can just start but we can't run it

Answer / ashok jami

Petrol have high volatile so completely mix to covert gases firm at atmosphere temperature. when using diesel in petrol not mix both air and diesel are in different form so even give spark not to burn so not started... In diesel engine using petrol. Fuel pump atomize the petrol when it reach self ignition then burn but high compression ratio the petrol engine starting knocking so not move..

Answer / adarsh gautam

in petrol engine need spark to ignite,which can't be used in diesel in the same way in diesel engine we need high compression to ignite which can't take place in petrol engine.

Answer / va6307

due to some schmucks, who forgot that they had petrol engine and fueled them selves with diesel, that car was fine till the petrol completely emptied and when the diesel kicked in the car was having all types of horrible knocking bumps

this experiment was done by a show "Fifth Gear" and the result was petrol car worked in diesel and diesel car worked in petrol, however the latter case experienced more trouble in driving

to answer your question, yes it is possible to interchange the fuel, but don't expect it to be smooth

Answer / bhanu pratap

yes we ca....but few running is possible....

Answer / manish kumar

star & run also due to mix of oil

What is Brinell's hardness test ?

0 Answers   Ashok Leyland,

1 TO 65

0 Answers   RRB,

Which minerals are used in the manufacture of cars?

0 Answers   GM General Motors,

The permanent reduction provided by the final drive in heavy vehicle is a) 4:1 b) 6:1 c) 8:1 d) 10:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

What are the points that must be kept in mind during forging design?

0 Answers   GM General Motors,

Due to drive torque, what is transverse weight shift?

0 Answers  

What is the working principle of hydrostatic propeltion system in a tractor?

1 Answers  

The Figure 1 depicts a) Top gear b) Second gear c) First gear d) Reverse gear

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

What is CX and DX mean or abbreviation for JCB Backhoe Loaders ? I know they are models 3CX is used in Europe and 3DX is used in India but I am looking for the full form of those abbreviations - Thanks

1 Answers   MGB Motors,

What is an injector pressure in heavy vehicles? Why it is used?

0 Answers  

The function of Differential is a) To prevent wheel skidding b) To reduce the speed of the inner wheels during turning c) To keep the speed of all the wheels same when going straight ahead d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

prove the relation for the torque required in order to accelerate a gered system?

0 Answers   TATA,