in internal combtion engine, maximum efficiency is65%. than
35% losses. but why not decreased losses ?
any reason behind this ?
there are many losses in i.c. Engines. Frictinal losses , heat transfer losses, losses due to cooling systems, evaporative losses & other unaccounted losses. Some losses can nt b eliminated but can b reduced upto limited extent.
Is This Answer Correct ? | 13 Yes | 0 No |
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is the function of a carburetor of a Motor Car? (1) Provides petrol vapour to the engine to produce power (2) Provides an electric spark for the fuel to burn (3) Provides clean air to the engine (4) Filters petrol
For the second gear in a synchromesh system, the drive transfer will be through a) U1, U2, C, F2, and splines b) U1, U2, C, F1, and splines c) U1, U3, D, F3, and splines d) U1, U4, U5, E, F2, and splines
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is the approx. temperature at the spark plug at the time of ignition??
i have chines vehicle Grand Tiger now its AC compressor become jam what should i do i have not found new in market
what is a stage time
Where is fan located in car?
How fuel tank capacity is decided for any two wheeler or four wheeler ???
The main advantage of a good clutch is a) Good torque transmission b) Rapid engagement c) Large size d) High inertia
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
Why dtsi technology is used in motor bikes?
Define Poisson's ratio.
Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,