The maximum amount of axial load to be applied on a clutch plate is
a) 100 KN
b) 200 KN
c) 300 KN
d) 400 KN
No Answer is Posted For this Question
Be the First to Post Answer
What do you mean by tempering?
What purpose to use damper pulley to engine?
IN automobile engineering what is the mean of auto i think auto means cars
What is the reason for emitting the white exhaust smoke during start of the vehicle?
What is the allowable -ve carnkacse pressure (vacuum) in the gas engine of 1.5 MW, what are the reasons and how it can effect the operation of the engine?
The function of the final drive is to a) Provide a permanent speed reduction b) To turn the drive round through 90o c) To provide drive to the rear wheels d) all of the above
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
how hand brake is operated when all the four tyres having disc arrangement
WHAT IS KING PIN OFFSET?
What is diff between SCADA nad DCS,Present which is new technology, Is dcs controls with out manual operation?
The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...
What will you do if you are offered higher salary at a different organisation while you are working with us?
inclination of fuel injector into cylinder
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)