Answer / niroshana

(2) To balance the torque applied on the main fan

Answer / jasvir singh

When a shaft rotates, reversible torque works on stationary part of machine, because Helicopter body is free in air and this reversible torque tries to rotate helicopter in opposite to main fan which leads unbalanciing to avoid this a little fan provided at rear end.

Why wheel type steerig is used in cars instead of hand steering used in auto-rickshaw?

0 Answers  

---

What is the difference between bs2 & bs3 engine?

0 Answers  

---

The torque transmitted by a clutch is given by a) T = μWR b) T = μ/WR c) T = μW/R d) T = 1/μWR

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What will happen if someone adds oil to the fuel of four stroke bike engine?

0 Answers  

---

basic difference between bsIII & bs IV

2 Answers  

---

is filter Generated ( Diesel filter & Air Filter) from Diesel Generators are Hazardous waste ?

3 Answers   RRB,

---

In case of a constant mesh gear box, when the left dog clutch is slid to the left by means of the selector mechanism, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...

1 Answers  

---

The crown wheel of the final drive is connected to a) Cage b) Spider c) Cross pin d) Axle half shaft

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

The permanent reduction provided by the final drive in heavy vehicle is a) 4:1 b) 6:1 c) 8:1 d) 10:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is bhp? How can you measure bhp?

0 Answers  

---

what is the syllabus for the rrb sec. eng. posts iam from automobile engg.

0 Answers   RRB,

---