Answer / faiyaz ahmad

Level troll is process or technique which is used to measure level in close tank or vessel
calibration of level troll weight the displacer and measure the diameter of displacer through vernier caliper after that calculate in computer then i will hookup link in apparatus and then
25% 50% 75% 100% again reverse 75% 50% 25% o% 4 mA 8mA 12mA 16mA 20mA

why to use 3 wire at RTD ? what's the reason for common wire ?

4 Answers  

---

i have one temperature TX in my loop check time once i was remove elament temp gose maximum then i am conect corectly but still now temp showing maximum what can i do this problem?

2 Answers  

---

What is two wire system and how it work

2 Answers   Bhel, IFFCO,

---

how many types of sensor in instrumentation

3 Answers   SRACO,

---

How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?

0 Answers   CCIE,

---

what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d

2 Answers  

---

What is the minimum rating availalbe for weld neck orifice in market?

0 Answers   Jindal,

---

What is the difference between EPROM & EEPROM.

1 Answers   Sabic,

---

What is three element drum level control system why its better than single element?

0 Answers  

---

What is the principle of capacitance type level transmitter?

0 Answers  

---

what is diff between sensors and transducers.explain with ex?

15 Answers  

---

Can anyone explain in a simple way the difference between DCS and PLC?

7 Answers   Honeywell,

---