Answer / jobby c johnson

thermistor is basicaly a temp measuring device.
At 25deg it is having a resistance value typically of 60k.
if we are placing thermistor in ac or in dc bridges then
the resonant frequency depends on the the value of
resistance. it is a useful measure for measuring high
frequency

what is sequence table in DCS . make a logic in sequence table for tripping of ID fan in Boiler(in YOKOGAWA CS 3000 DCS).

1 Answers   Yokogawa,

---

hw to calibration a control valve?

3 Answers  

---

1)What is the suitable MOC for flow meters working at temperature between 200 - 250 cen. 2)In which application the mass flow meters are not advisable 3)Is it advisable to use radiation type or radar type instrument for non contact application

1 Answers  

---

What is hp & mp seperator .& what is its working principle ?

0 Answers  

---

what is vibration sensor working principal and how many types its has??

5 Answers  

---

Calibration procedure for electro magnetic flow meter

0 Answers  

---

WHY WE R NOT USING THE TURBINE FLOW METER IN THE STREAM SERVICE ? pl explain?

3 Answers  

---

why flow transmitter showing 2.2ma?

2 Answers  

---

in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.

0 Answers  

---

In close vessel/ drum why we use d.p. transmitter of -ve range i.e. (-)500 to 0 mmwc.

2 Answers   IMECO, Voltech,

---

Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...

0 Answers   Adgas, GAIL, Oil India, ONGC,

---

What is surge and how is it prevented.

1 Answers   ADMA OPCO,

---