Interested to Buy Any Domain ? << Click Here >> for more details...
How will you calibrate an interface level trol/normal level
trol in line and in w/s?
- 1 Answers
- 2987 Views
- CCIE, I also Faced
- E-Mail Answers
Answer Posted / faiyaz ahmad
Level troll is process or technique which is used to measure level in close tank or vessel
calibration of level troll weight the displacer and measure the diameter of displacer through vernier caliper after that calculate in computer then i will hookup link in apparatus and then
25% 50% 75% 100% again reverse 75% 50% 25% o% 4 mA 8mA 12mA 16mA 20mA
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to find out the current of two motors having same power consumption but different RPM?
In turbine, what does term CDP, NI, NH, HSSOC, means
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
What are different types of orifice plates? State their uses.
Do you have reference list?
Explain the key components of control loop?
May I have a brief note above the voltage barriers? Whats is the purpose? Please mail me if you've operational details, mail id: rajkumar.diice@gmail.com
explain key exchanges in all security modes WPA,WPA2,TLS?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
how to control pid
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
