Answer / kuruseelan

The shunt connection in four point starter is provided
separately form the line where as in three point starter it
is connected with line which is the drawback in three point
starter

1.type of oil in used in transformer.

9 Answers  

---

What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.

0 Answers  

---

What is frantic effect?

0 Answers  

---

low frequency protection why recomend?

0 Answers  

---

how can H.V busbar in a powerstation can be protected?

1 Answers   Unitech,

---

what is bus pt and what is the function of it

2 Answers  

---

Two CTs 1600/1 and 35/1 are in series. while checking the ratio test of a CT(1600/1),same 1600A will also pass through the CT having ratio 35/1. Will it be harmfull to the ct(35/1),if yes , what will happen.CT secondary is shorted

3 Answers  

---

what is differents between static stablizer and servo stablizer

3 Answers  

---

1.Whats the use of GNAC(Generator Neutral Accessory Compartment) 2. why generator or any other system require Neutral Grounding and not Phase grounding 3. what happens if any one of the phase is grounded. 4. if 15kv is grounded directly what will happen, why it should not be grounded like that 5. use of of NGTR(Neutral Grounding Transformer and Resistor) for grounding is helpfull and how

5 Answers   BEMCO, CSS, Powergear,

---

What is the difference between earth fault and restricted earth fault protection?

1 Answers  

---

What is the standard height of installation of Socket & switch from Finish Floor Level as per the IEC/IS Rules?

1 Answers  

---

7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?

0 Answers  

---