what is the difference between main meter CT and check
meter CT?and what is the difference between main meter PT
and check meter PT?
- 2 Answers
- 15453 Views
- Tesco, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
In case of gen stations both are identical , there is no
difference at all
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
State ohm’s law?
what are the application of over current relay?
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
What is the end effect of linear induction motor ??
Single line digram for 11 kV to distribution use go,la and do
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
where does 22kv line starts
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
We are designer please help me calculate the size of 11kv cables from step up transformer to M.V panel, total load is 5 mega watt distance 900 feet (used aluminum type cables) please provided formula for calculate the cable with example.
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
What is the phase relationship between the primary and secondary voltages of a transformer?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
what is mean by drives?
