What is the difference between Contactor and Circuit
breaker ?
Answers were Sorted based on User's Feedback
Answer / vinayakamoorthy.k
The Circuit Breakers are will trip(Current Operated Device)when the current will goes over the limit(Current Rating).But the contactors are not going to trip.
| Is This Answer Correct ? | 10 Yes | 3 No |
Answer / sumit patel
There are two main difference bet'n contactor and circuit braker
1) contactor is used for low voltage while CB is used for high voltage.
2) contactor only make contact between line and load.there is no tripping mechanism. while in CB is current operated device.which has a tripping mechanism.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / prakash rao
Contactor operates for low currents, whereas circuit breakers used for high currents.
| Is This Answer Correct ? | 1 Yes | 0 No |
My above answer appears to be wrong.Contactors are for
closing circuit and are to be opened manually.Circuit
breaker has a tripping (opening) mechanism and may have
closing mechanism also.
| Is This Answer Correct ? | 0 Yes | 1 No |
You can add that contactors are to be operated off-load only
| Is This Answer Correct ? | 0 Yes | 1 No |
Opening and closing are done manually in case of contactors
and for cb it is electrical
| Is This Answer Correct ? | 0 Yes | 3 No |
Answer / sumit patel
contactor is used for low voltage while circuit braker is used for high voltage.
| Is This Answer Correct ? | 2 Yes | 6 No |
Answer / vijay
CONTACTOR RICIEVE INPUT COMAND AND ELECTRIC OPERATING
CIRCUIT BREAKER IS OPERATING MANUVALLY
| Is This Answer Correct ? | 0 Yes | 9 No |
why 1.7Uo for HV cable Hi pot test?IE standard why?
HAT IS THE EFFECT OF LOW POWER FACTOR ON THE GENERATING STATION?HOW WILL YOU IMPROVE THE LOW POWER FACTOR?
how to calculate the minimum permissible limts of insulation resistance of switchyard equipments
What is a HRC fuse (Full form)
26 Answers Gammon, HRC, Moser Baer,
what happen if drive input fail momentry at 48.5 HZ frequency?
What about electrical Units. discrive in detail
give me applications of sequence bridges . (used in 3 phase un balanced systems)
What are the conditions to be satisfied before connecting two DC generators in parallel?
What is x/r ratio?
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
what is need of air gap in expansion section in busbar?
What happen while we measure the Current in Rotor?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)