how to calculate of which rating transformer should be selected? take any example

2 Answers  

---

Here iam a question with SYNCHRONIZATION PANNEL related issue, as i want to design a SYNC.pannel board iam giving the 2 nos of 1MVA Generators to sync pannel , then what wil be the out put of the sync pannel, whether it wil be one cable coems from the sync panel or two cables.. as iam using two transformers to meet my load demand, so pls clear me whether two cables comes from sync panel to connect to transformers or only one cable

3 Answers  

---

checking procedure of capacitor based motors.used in fans etc?

0 Answers   Badve,

---

can you check the current and voltage of a 12 V battery by a digital multimeter in this fashion that apply the digital multimeter across the battery terminals directly ? say yes or no ... i sais yes ........... is this true or false ? plzz tell me and also explain ........ plzz thanks

4 Answers  

---

How we can defined theecopper cable size if we know the aluminium cable size?

0 Answers   Cummins,

---

What is a surge supressor why its is used in synchronous generators

0 Answers  

---

if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)

1 Answers  

---

What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB

0 Answers  

---

what is Aircraft earthing and what does it do?

6 Answers  

---

In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?

0 Answers  

---

Under wat condition statcom operates as an inductor for the transmission line?

0 Answers  

---

IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.

0 Answers  

---