Answer / ramesh gaur

There are two types of exciters, static exciter and rotory
exciter.purpose of excitor is to supply the excitation dc
voltage to the fixed poles of generator.Rotory excitor is
an additional small generator mounted on the shaft of main
generator. if it is dc generator, it will supply dc to the
rotory poles through slip ring and brushes( conventional
alternator). if it is an ac excitor, out put of ac excitor
is rectified by rotating diodes and supply dc to main fixed
poles.ac excitor is the ac generator whose field winding
are stationary and armature rotates. intial volatge is buit
up by rsidual magnetisim.

Answer / tameshwar singh

Exciter is a device or cobination of devices whcih supplies
the megnatising current to generate the working flux.
In industrial applications basically 3 typpes of exciters
are used in alternator-
1)Static exciter
2)Permanant mannet/Brushless exciter
3)DC/Pilot exciter

Answer / gawande shubham

Exicter is provided the DC power to the genrator field winding

Answer / vaishnavi

exciter is electrical device which is use to providing magnetising current to provide dc excitation to the generator

Answer / jana

a thing that produces excitation, in particular a device that provides a magnetizing current for the electromagnets in a motor or generator.

Answer / hari

for switching purpose we r using exciter in alternator.in case of alternator we want some current like 4600 A we can't get directly so we use exciter that exciter field winding will transfer the flux to alternator winding .so we can get that much current.

Answer / vishal

HELLO,

CAN ANY ONE TELL ME FROM WHEIR WE CAN GET A PILOT EXCITER FOR FOR AC ALTERNATORS FROM 20 TO 50 KVA, WE MANUFCATURE ALTERNATORS AND NEED BULK SUPPLY VISHAL GARG email info@vidhataindia.com

What is OLTC in transformers and what is its function?

4 Answers  

what is max. continous current of LT side of distribtion transformers? ie for25kVA, 63kVA, 100kVA, 200kVA etc

2 Answers  

the voltage per turn of a primary winding of a transformer is the same as the voltage per turn of the secondary winding of the transformer. why?

8 Answers  

ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.

0 Answers   ONGC,

How feedback transformer works to feedback power in Slip Power Recovery System

2 Answers  

in transmission line 11kv is step up or step down? why?

5 Answers  

How is the gain affected by the introduction of feedback in a control system.

0 Answers   GE,

State the frequency for rc phase shift oscillator?

0 Answers  

Our Alternator nameplate specifies a power factor of 0.8. When the Alternator is on light load, the bus bar voltage rises to 11240 volts, whereas the standard value is 10500 volts. Is it ok to increase the power factor to 0.85 or 0.9. I am afraid because the power factor on the name plate is only 0.8 ?

3 Answers   Escube,

any body can give me idea or sketch of fuel(Diesel) level controller for genset.

1 Answers  

can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??

0 Answers   MCB,

upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.

0 Answers   ABC,