3- What is the target from Zero Impedance, Single Phase
Imp., S/C Imp. and magnetic balance tests?
No Answer is Posted For this Question
Be the First to Post Answer
What is meant by regenerative braking?
what is ICU and ICS in breaker ratings
in catridge heeter watts =110, 260 v , i checked in multimeeter meeter shows 50 ohms but oms law r=v square /w 260*260=67600, and 67600/110=614.5 ohms how to caluclate exact ohms in heetre s
what is diffrence between primary & secondry transformer?
what is PPI DB?
2 Answers Priyanka Electricals,
how oti and wti connections are different from each other?
IN 6.6KV 3 phase switch gear .i will give 6.6kv to R phase only to earth in during H.v testing (through H.v KIT).what happen remaining phases.how much voltage get remaining phases.why? explain.
transformer test
when a primary current injection test is required, it is accomplished by what?
which type of insulation are used on 132kv transmission line
in 50 mw generator if field is open in full load running condition what happen and for protection which relay used?
X/R ratio in 11kv transmission line is?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)