How will you justify IR value
and Charging voltage of any
motor,transformer and
Cables.......????
.
.
.
.
.
.
.
.
Plz tell me any body
Baljeet Singh,
engineer_89@refiff.com
No Answer is Posted For this Question
Be the First to Post Answer
If the capacitor feeder is switched ON without any load, is there any display in the ammeter at the incomer?
Define average demand?
6.6 KV /.415KV Step down trf. we can get 6.6 KV from primary by applying .415 KV secondary side by same TRF.
What does impedance in the windings of transformer signify.
what is hourly consumption of coal in therma plant
why the neutral of power transformer is always earthed?
How impulse levels are calculated that for 11kV impulse is 75kvp, for 24kV impulse is 125kvp ?
Rccb trip or not with out neutral connect in three phase welding machine
which motor is used in mixies
Equal resistance of 100ohm each are connected to the arms of whestons bridge, which is supplied by 2v battery. The galvanometer can sense a current low as 1microAmp. What is the smallest resistance that can be measered.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
Why not implimenting power factor in Diesel generator