How do you find the difference between 53&43 grade cement in site?

Categories >> Engineering >> Civil Engineering
Suggest New Category

How do you find the difference between 53&43 grade cement
in site?

Question Posted / balu_b86

6 Answers
12395 Views
L&T, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How do you find the difference between 53&43 grade cement in site?..

Answer / alok rav

The OPC was classified into three grades, namely 33 grade,
43 grade and53 grade depending upon the strength of the
cement at 28 days when tested as per IS 4031-1988. If the 28
days strength is not less than 33N/mm2, it is called 33
grade cement, if the strength is not less than 43N/mm2, it
is called 43 grade cement, and if the strength is not less
then 53 N/mm2, it is called 53 grade cement.

Is This Answer Correct ?

34 Yes

6 No

How do you find the difference between 53&43 grade cement in site?..

Answer / dalip

You can
find the
grade of
mark on
cement bag

Is This Answer Correct ?

9 Yes

7 No

How do you find the difference between 53&43 grade cement in site?..

Answer / santosh

it has been mentioned on the top of the cement bag

Is This Answer Correct ?

5 Yes

4 No

How do you find the difference between 53&43 grade cement in site?..

Answer / praneeth

the amount of heat produced varies for all grades of cement
when mixed with water.Its high for 53 grade and low for 33
grade

Is This Answer Correct ?

5 Yes

6 No

How do you find the difference between 53&43 grade cement in site?..

Answer / md.waseem athar

the difference can be found between 53 and 43 grade cement by compressive strenght test of cemnet at site...

Is This Answer Correct ?

2 Yes

3 No

How do you find the difference between 53&43 grade cement in site?..

Answer / pradeep

surface area is increased for 53, because of more fineness and pulverisation

Is This Answer Correct ?

1 Yes

3 No

Post New Answer

More Civil Engineering Interview Questions

For G+4 storied building having 76000 sft per each floor, can you prepare schedule in such a way that structure should be completed with in 41/2 months and finishing be completed with in 51/2 months?

1 Answers

what is the procedure for flakiness and elongation index

1 Answers

mix design procedure, i.e m15 to m40

1 Answers Power Grid, SMG,

How much of the strength of concrete comes from post- production curing?

0 Answers EE Limited, Focus, Lafarge,

in a building why we are using T beams? why can i adopt beam bottom & Top level as same as slab bottom & Top level?

0 Answers UltraTech,

what grade of concrete to be used for lintel when reinforced with bamboo in place of steel?????????

2 Answers

What is the finess modulus of sand?

19 Answers

What is the dimension of Slump cone which is used to measure the Slump value of concrete? Slump value for Pile concrete? Slab concrete? Column concrete?

3 Answers

apparatus of soundness test of cement

5 Answers

Why are L-beams (cast monoloithic with slab)that usually occur at the slab edge, provided with overhangs?

1 Answers

What is the bending moment ?

1 Answers L&T, Manav Infra Projects,

Why we check specific gravity of admixture when we receive it? What is it's significance.

1 Answers

For more Civil Engineering Interview Questions Click Here