Pls anyone explain
me the basics of
wiring a house?
Answers were Sorted based on User's Feedback
Answer / jumaa errfadi
for lamps you can use 1.5mm wire .
for ordinary sockets in rooms use 2.5 mm ((but the supply
wire from mains switch to distribution box should be 4 mm ))
for kitchen ,A.C , water heater use 4mm wire ..
this is in short .if you need mor info. write me .
| Is This Answer Correct ? | 0 Yes | 0 No |
Is there thumb rule to calculate how many Insulators to be used for Transmission line of different volatges
what is the use of capacitor in online ups?
HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii) DELTA LOAD, USING A CLAMP METER. NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO WE GET?? PHASE CURRENT OR LINE CURRENT.
IN CABLE TRENCH WHY FILL UP THE SAND. AND WHAT IS THE DIFFERENCE BETWEEN OVER HEAD AND UNDER GROUND LAYING THE CABLES
can someone explain that how the speed of the protection system affects the fault level calculation?
What is the generating voltage of a power station consided generally?
what causes contact chatter when there is no demand on the air conditioning unit?
what is slip what is the use of slip?
what is power factor
mention hazard experienced during installation
How many VSC based HVDC are there in India and the world
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)