57. Calculate the volume of a truck loaded with stone
chips whose data are as follows–
5
Top Length - 13-9, 13-10, 13-09
Bottom Length - 13-11, 13-10.5, 13-10
Top width - 8-7.5, 8-8, 8-7
Bottom width - 8-7, 8-8, 8-7.5
Depth - 2-0, 1-11.5, 1-10, 1-11, 1
-10.5, 1-11.75, 1-11
No Answer is Posted For this Question
Be the First to Post Answer
how much steel is required foe following components.. footing- plinth beam- column- beam- slab-
what is the maximum height of concrete casting.
Previous IS steel code?Thanks.
How to calculate plastering for elevated water storage tank
WHAT SHOULD BE THE THICKNESS OF CEMENT M-SAND MIXER IN BETWEEN TWO SOLID CEMENT BRICKS USED FOR A HOUSE WALL?
what is zone a n zone b?why the spacing of ring in zone a less.n zone b high?
How much binding wire required in 1 MT Reinforcement? How much Nails Required in 1 Sqmtr Area work progressed
mix design of concrete using indian standard methods
In a beam tension is always at the bottom but sometimes when we design using staad we get more number of rebars at the top compression zone Why?
How to activate isometric axes in cad?
which member is very strong (strength) after the cross- section area is same, pipe section or solid rod section ? no that's not my question, my question is why pipe section is strong ?
Typical floor design load in Residential Building----------- -----