Answer / kj

The voltage is caused by a chemical reaction. This reaction
can not produce a higher voltage. By putting more rows of
plates it does not change the reaction to increase the
voltage only the amount of current that can pass through
the cell.

how to calculate the multiplication factor in HT incomer trivector meters

9 Answers   Dalkia, Getco, Gujarat Energy Transmission Corporation Limited GETCO,

---

What is maximum AC & DC transmission voltage in India? and where?

12 Answers  

---

how does a liquid starter reduce the starting currents?

0 Answers  

---

how you taken aotitude test

0 Answers  

---

what is the meaning and difference between ELECTRICAL DRAWOUT and MANUAL DRAWOUT?

3 Answers  

---

what is the method of electric earth for the protection of low voltage electric equipment

1 Answers   MacLellan, Shiva Corporation, Siemens,

---

why we use mostly 3-phase but not 4-phase and 5-phase what is the difference between them

1 Answers  

---

How to improve insulation resistance of Motor

2 Answers  

---

the fuse is use for protection against overcurrent but at normal condition it carry the rated current then how single thin wire carry this current without melting

1 Answers  

---

if our motor load is 150 amp v- kv and we want to install capacitor bank then what is the exact value of that capacitor bank that we should install?and how we calculate that

0 Answers  

---

according to ohms law ,the voltage increases then current is what happened?

4 Answers   NTPC,

---

the winding of Generator and Motor is star or in delta ? and why

0 Answers  

---