Interested to Buy Any Domain ? << Click Here >> for more details...
Why Lead-Acid cell voltage is 2.1 volt, why we can not
chenged it cell voltage by using extra row-material, only
incries its AH.
- 1 Answers
- 3632 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
The voltage is caused by a chemical reaction. This reaction
can not produce a higher voltage. By putting more rows of
plates it does not change the reaction to increase the
voltage only the amount of current that can pass through
the cell.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why it is so called as xlpe(cross linked poly ethyline) cable?
What is the distance between each insulator in 33kv transformer and how can it calculate
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
what is p.s impedance measurement test in earthing transformer?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
What are the application of filter?
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
how can decide the current rating of oltc
how does WTI work ?
what is interpose? where it is used and why it is used?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
what is sevice settings for mccb?How can be it setted?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
