For the purpose of inflating car tyres, spray painting, etc. i.e. say a small

For the purpose of inflating car tyres, spray painting,
etc. i.e. say a small workshop, what size of a compressor
(CFM) is recommended? It will be generally for a hobby use
and not commercial use.

Question Posted / pramod

1 Answers
4472 Views
I also Faced
E-Mail Answers

For the purpose of inflating car tyres, spray painting, etc. i.e. say a small workshop, what size ..

Answer / manjunath

spray painting it is generally used for painting in a very
smaller areas of any part and where it is very hard to paint
in a brush .... And to improve faster rate of painting,,
spray painting r used........usually reciprocating
compressor r used but size depends upon requirement...........

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Automobile Engineering Interview Questions

what is balancing?

1 Answers CFB, Global Automotive Research Centre, ITI, MAHINDRA, Shriram Pistons Rings,

State two to three differences between two stroke and four stroke engine?

0 Answers Ashok Leyland,

on how many points, an engine-clutch-gear box unit is supported on chassis frame ?

4 Answers

What is the composition of Cast Iron Grade:GG P70 ?

0 Answers

The resistance to the vehicle motion whose magnitude remain constant with respect to the vehicle speed is a) Resistance due to gradient b) Resistance due to the road c) Resistance due to the tyre friction d) all of the above

0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,

What is Kirchhoff's Law ?

0 Answers Ashok Leyland,

What is pitching in the suspension system?

0 Answers

what is meant by 1)1.8 TSI 4V 1798cc turbocharged 2)2.0 TDI PD 3)bhp 4)front wheel drive car 5)four wheel drive car

3 Answers

Why do you want to change your present company??

5 Answers

If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above

0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,

My Isuzu common rail 4Hl 1-1 tipper caught to flood & water absorb to engine through air intake line (air cleaner) then I put new pistons, rods everything its needed. But now when I start the engine its try to start with normal starting sound. I try to start until battery getting low, but nothing happen. What can I do? Please help me to resolve this problem.

1 Answers

How air conditioners work in cars?

0 Answers

For more Automobile Engineering Interview Questions Click Here