Answer / a k vaidya

In order to distribute load on larger area ,as per the
bearing capacity of soil,width of foundation is increased
down wars in steps . This is adopted espewcially in stone
or brick masonary.

Answer / tango

In any engineering , at ground level we do grouting, we have two options either the grouting to be finished upto ground level or if we go for raised grouting in that case we go for step foundation.

Why are steel plates inserted inside bearings in elastomeric bearings?

0 Answers  

---

if there is no alternative of silty sand avail near ,then how it is used in cement mortar or concreting?

2 Answers  

---

What is meant by Crystal Concrete?

0 Answers   Jain Housing,

---

how to calculate length of bar

4 Answers  

---

what is bulkage

4 Answers  

---

---

what is zero slump concrete

5 Answers  

---

How To Measure Honey Comb Full Brick Work, Can we deduct Hole, If Yes, how to Calculate Rate Analysis

1 Answers   HMM, Metec,

---

curing duration

5 Answers   Arun Excello, L&T, Proton Construction,

---

What is the veriplus for ellips card length formula (major axis 3.4m,minar axis 2.6m spacing 0.2m

0 Answers  

---

which member is very strong (strength) after the cross- section area is same, pipe section or solid rod section ? no that's not my question, my question is why pipe section is strong ?

2 Answers  

---

in the earthquqke the profile of water on dam is parabolic or not

0 Answers  

---

plastering ratio 1:3

3 Answers  

---