Answer / n bala krishna

IF THE TANK LEVEL IS 0-100%, BUT IF YOU WANT TO MAINTAIN
30% AS THE MINIMUM LEVEL OF THE TANK. AFTER FILLING THE
TANK WITH 30% SOLUTION, I WILL PRESS ZERO TRIM. AFTER
PRESSING ZERO TRIM THE TANK WILL SHOW 30% LEVEL AS 0% IN
DCS.

Answer / mithilesh kr

any transmitter,control valve etc.
are follows 0-100% range.
0% called zero and 100% called span.
for setting of 0-100% of any trim
is required

What is eddy current? Describe the operating principle of proximity probe.

0 Answers  

---

suggest a sensor to measure rapidly varying temperature?

1 Answers  

---

why t/c is connected parallel and what is the purpose of it

2 Answers  

---

what is electric motorised valve working principle.

1 Answers  

---

what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?

0 Answers  

---

Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)

1 Answers  

---

Hook up resistance decade box to temp.transmitter.

0 Answers   CCIE,

---

what is the characteristics of control valve?

7 Answers  

---

Possible cause of IOP alarm in a DP transmitter: a: IOP-minimum b: IOP-Maximum

4 Answers  

---

Identify the electrical variable that is either directly or inferentially used by various instruments to determine the value of a measured variable.

4 Answers  

---

What is hp & mp seperator .& what is its working principle ?

0 Answers   Chevron,

---

Dear Sir/Madam, I am attending an interview for ETs in BHEL. I have cleared my written test under Electronics (Instrumentation). This is the first time I am appearing for an interview. Can any one who has attended the interview earlier give me a clue to face the interview. With regards Sindhu

2 Answers   Siemens,

---